Ballroom 1 Video

Video/Projection Systems

Go to the Projection booth. On the Left rack there is a touchscreen. Touch the screen to activate.

POWER ON Main Projector

This process takes approximately three (3) minutes to complete. From the touchscreen home page:

Select Video Inputs

From Screen 2:

1. Choose a projector source.
3. Place your finger on the desired video source icon (i.e. HDMI 1, HDMI 2).
   1. With your finger still on the icon, drag the icon to the center of the screen.
   2. Release your finger from the icon and touchscreen.

Inputs and Source Selection

The HDMI inputs support DHCP (Dynamic Host Configuration Protocol).

Physical Video Inputs

• HDMI 1 / VGA 1
  • Use the VGA + Audio connection to connect a laptop or computer with a VGA and 3.5mm audio output cable. DOES NOT support DHCP (Dynamic Host Configuration Protocol).
  • Use the HDMI connection to connect a PC or Mac laptop, computer, DVD player, Blu-ray player, the CineLink streaming movie player, or any device with an HDMI output. Supports DHCP (Dynamic Host Configuration Protocol).
• HDMI 2 - Use to connect a PC or Mac laptop, computer, DVD player, Blu-ray player, the CineLink streaming movie player, or any device with an HDMI output. Support DHCP (Dynamic Host Configuration Protocol).

SECV Commercial Channel Lineup.

POWER OFF Main Projector

From Screen 2:

2. Touch the the bottom icon that looks like a circle with a diagonal line through it. The main projection screen and main projector in BR 1 will begin to ascend. Both will automatically stop at a disignated point. During this time the projector is powering down.

BR1 large projection screen

Room 1, 2, 3 small projection screens

To lower or raise the small projection screen in each room, press either the down or up button.

Sound for Video - Connect a mic cable (XLR) to the wall mic input that says "AV".